OK.. Just traded a trans for a 2.0 that needs rebuilding.
PO mentions that crank was worked on and never use..BUT also mentions
You will need .10 under on the main bearings and standard on the rods.
I've looked at several web sites...now I have to bug this 914 family.
Any one have a set and or any leads on a set?
Thanks in advance!
I though I saw some on theSamba or Ebay.
Sounds like you should disassemble the engine FIRST to determine if the crank is even useable, or needs turning again., Otherwise you may be wasting your money on bearings you may not need.
It's not .10 under it is .010 under, big difference when you write it. (.10 would be 100/1000 and .010 is 10/1000 of an inch)
Almost all machine shops will call it "10 under" or "10 thou. under", but technically it is 10 thousands of an inch undersize.
.010 under is a standard/imperial measurement system undersize and it's the same as .25mm which is a metric measurement system undersize.
I wouldn't trust a PO, measure it or get a machine shop to do it. Most will do this no charge.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)