Printable Version of Topic

Click here to view this topic in its original format

914World.com _ FS/WTB: 914 Parts _ WTB - Spacers for CV joints

Posted by: schuh1129 Nov 20 2010, 06:05 PM

Looking for spacers/plates for my CV joints. Does any one know if these are the same that would be used on water cooled VWs ? Thanks Mike

Posted by: Eric_Shea Nov 20 2010, 07:35 PM

Posted by: schuh1129 Nov 20 2010, 08:17 PM

Eric, thank you for passing along this information on PMB. I didn't see the spacers listed but I sent them an e-mail asking if they they had any in stock? Thanks Mike

Posted by: bdstone914 Nov 21 2010, 08:15 AM

Mike,

I think you are referring to the small plates that each pair of CV bolts goes though.

They are on the left side of the picture

I have lot of those along with the CV bolts that were cleaned and gold zinc plated.

There are two required for each CV or a total of eight for both axles.

I can sell a set of eight for $15 shipped. Include the bolts for a total of $25. I think I am out of the serrated washers for the bolts.

Bruce

Attached thumbnail(s)