Printable Version of Topic

Posted by: tornik550 Nov 25 2010, 10:47 AM

I was building a 2270 and decided that it is probably time to scrap my project. I was just building it for fun but I keep running into issues and I really do not want to spend the money to fix.

I am looking for a god usable 2.0 crankshaft and rods.


Also- I have a 78mm cw crankshaft. It from the type 4 store. I has been used but I only ran the car for about 250 miles before a head problem cause e to disassemble the engine. It has chevy journals. T4store part number 2033.

I also have a set of H-Beam connecting rods for sale. I also purchased them from the type 4 store. They are 5.7" in length. They are clearanced for a 78mm crank. T4store part number 3045.

Posted by: silver74insocal Nov 25 2010, 10:54 AM

pricing

Posted by: tornik550 Nov 25 2010, 11:06 AM

300 plus shipping for the crankshaft and 150 plus shipping for the con rods. I can take pics later if you want however my wife is telling me we have to go to thanksgiving dinner.

Posted by: dangrouche Nov 25 2010, 11:22 AM

I got these three rods from my 2.0 that threw a valve; all three of these shipped to you in Ohio for $25 shipped by Priorty Mail with delivery confirmation. more pics if desired. I believe these rods have not been worked on previously.


Attached thumbnail(s)

Posted by: Mark Henry Nov 25 2010, 12:05 PM

I have a couple of sets, but shipping from Canada is more expensive than if you can find it local.

Posted by: ws91420 Nov 25 2010, 05:14 PM

I have what appears to be a counterweighted 2.0 crank and rods that have been rebushed w/ all bearings. Would you consider trading for the 2270 crank and rods?

Posted by: ConeDodger Nov 26 2010, 07:22 AM

I have a set of stock rods and a stock 2.0 crank. $300 + Shipping for all. Came from my original engine which is a documented 70K mile car.

Posted by: HAM Inc Nov 26 2010, 01:31 PM

I apologize for going off topic, but I'm curious about the head problem you had. Would you mind sharing?

Posted by: r_towle Nov 26 2010, 02:34 PM

What pistons are they setup for? Stock 2.0 liter pistons (or 96mm) with the stock pin height?
Stock main bearings?
Wrist pin size?
If its all stock and I dont have to go shopping for odd sized main bearings (unless you have those also) then count me in.
If so, I am interested to buy the crank and rods.

Send me a PM with all the details you can remember.

Rich

Posted by: markb Nov 27 2010, 11:16 AM

We also have a crank & rods if you're still looking.

Posted by: tornik550 Nov 27 2010, 11:22 AM

I appreciate everyones responses. Thanks to a gracious gift, I am just going to continue on with my 2258 build. Because of the gift, it is going to be cheaper for me to finish the 2258 than change to a 2056.
Thank you