Heads are 2.0 for a big bore engine 112 mm is what i measured them too.. 150.00
112mm OD? any idea what valves go in these?
44 mm in 38mm exh 8mm stem
What year are they 73-74 or 75-76?
Why are you selling them?
Are the fins intact?
I am interested in getting them.
Joe
Not sure what year they are from.. Not into the type four stuff I was going to use them as a demo head for dispersant coatings..
I got these from a well known shop from
San jose campbell from a big bore
Race car
What city are you in? I'd like to see these heads and possibly purchase them. Do the heads come with valves and rockers? I'm in Santa Clara.
I am in San Jose No rockers but have valves retainers and springs.
Sounds good to me. How does your Friday look?
going too my ranch in napa friday i can take them to santa clara tonite
I just got home a bit ago but should be home earlier tomorrow. I'm on Monroe, off of Bowers. How about you?
I'm by alum rock park I am gonna be in Santa Clara tomorrow at the welding store by the air port
I'll PM you my telephone number.
Sold
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)