Printable Version of Topic

Click here to view this topic in its original format

914World.com _ FS/WTB: 914 Parts _ WTB: Side shift Ball Pin and boot

Posted by: ScottD914 Feb 1 2011, 03:57 PM

Thanks to the PO for running for years in the Northeast without a rubber boot! chair.gif
The toll that road salt takes! Yikes! She said "it shifts a little funny"
Ah...Yeah... poke.gif

Anyone have a "Ball pin" and a side shift boot for me? Thanks, ScottD

Attached Image

*That ain't pretty!

Attached Image

Posted by: Krieger Feb 1 2011, 06:49 PM

That looks like its gonna be a pain to remove.

Posted by: 70 914 Feb 2 2011, 09:26 AM

I think i hav a new boot !?

Posted by: ScottD914 Feb 2 2011, 10:45 AM

QUOTE(70 914 @ Feb 2 2011, 10:26 AM) *

I think i hav a new boot !?


Thanks! PM sent.

Posted by: 914LIVE Feb 2 2011, 11:01 AM

QUOTE(ScottD914 @ Feb 1 2011, 01:57 PM) *

Thanks to the PO for running for years in the Northeast without a rubber boot! chair.gif
The toll that road salt takes! Yikes! She said "it shifts a little funny"
Ah...Yeah... poke.gif

Anyone have a "Ball pin" and a side shift boot for me? Thanks, ScottD

Attached Image

*That ain't pretty!

Attached Image


___________________________________________________________

Good morning.

I have a Ball Pin and Fork. I suggest replacing
as a set.

Thank you, TOMAS.

___________________________________________________________

Posted by: ScottD914 Feb 2 2011, 11:15 AM

Thanks Tomas, PM sent

Posted by: Dr Evil Feb 2 2011, 05:14 PM

No need to replace the fork. It is in the case and they are not a matched set. If you dont score from those folks, let me know. I have all that stuff. Also, you could, and I know this sounds ghetto, clean the ball off and fill the pock marks with quick steel. It would work fine, but getting another boll is about as easy smile.gif

Good luck!

Posted by: ScottD914 Feb 2 2011, 06:00 PM

QUOTE(Dr Evil @ Feb 2 2011, 06:14 PM) *

No need to replace the fork. It is in the case and they are not a matched set. If you dont score from those folks, let me know. I have all that stuff. Also, you could, and I know this sounds ghetto, clean the ball off and fill the pock marks with quick steel. It would work fine, but getting another boll is about as easy smile.gif

Good luck!


Ghetto is right, but I have to admit, the thought did cross my mind! I was thinking JB Weld or the like. stirthepot.gif

Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)