Got Em!!!
We need a set of headers for a 914-6, stock 2.0 engine, don't need heater boxes as these will be for Dyno use. Lots to offer in trade..
TIA..
This is the engine for my 914-6 GT clone)
I have a set of 914-6 (original) .. a little rough though... but i think i could not be farther away (BC, Canada)
PM me if your interest peaks...
Gary
Attached thumbnail(s)
FS? WTB? WTT?
ok. here are more pics. the pipes are good, although pitted. the heat exchangers are bent or perforated in some spots.
comments?
Attached thumbnail(s)
Talking about the thread title:
We've established the following guidelines to help make your sales/purchases as successful as possible!
- Please List WTB:, FS:, TRADE: etc (want to buy, for sale, and trade respectively) before your add title.
Contact Cliff Brown at 415-846-1680 or clifton_brown@hotmail.com
He has a set of headers in his garage.
Hope this helps,
Chris
Byron, I might have what you want! I have a set of 914-6 headers that I cut the Heat exchanger part off. The pipes under the HE are in good shape but the part that was exposed are not so good and would have to have the last 12" rebuilt. If you want them for a dyno pull you would not have to reweld the flanges on , just fit the three branches into one pipe. If you are interested for $250 let me know and I'll take pics. AL
I think you can buy these from Triad for fairly a inexpensive price. Then there is always MSDS.
Thanks all, got a set on the way.. These will be getting O2 bungs on each tube to tune each cylinder while on the dyno..
Thanks all..
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)