Printable Version of Topic

Posted by: JimmyG Feb 12 2011, 11:20 AM

I am looking for a nice 9146 tranny case for a project I am working on.
I want one without any oxidation or interior water damage. I am transfering my components from my 70 911 901 so I can go to the push clutch
Let me know if you can help!
Jimmy

Posted by: 914Sixer Feb 12 2011, 08:28 PM

914 trans cases are the same. Gear set and end cap make it a -6 along with number stamped on the rib.

Posted by: 396 Feb 12 2011, 09:51 PM

Correction... please look at a -6 case vs a 4 case ..there are slight differences

Posted by: JimmyG Feb 13 2011, 07:48 AM

There is some small differences. This will be for a original -6 so I want to use a case that will be correct.somebody surley has a bare case laying around.

Posted by: FourBlades Feb 13 2011, 10:29 AM

I have a good 914/6 tail piece if you end up needing one.

John

Posted by: JimmyG Feb 13 2011, 12:07 PM

Thats John but I am going to use my stuff from the conversion car with a side shift. All I really need is the bare case. I built my original -6 case at Georges when we where there.
BTW; your cars are looking good!

Posted by: carr914 Feb 13 2011, 03:54 PM

I have an empty -6 case some in my stash, if I can just find it

Posted by: JimmyG Feb 13 2011, 03:58 PM

Do some digging T.C ! would love it if ya found it!

Posted by: bam914 Feb 13 2011, 04:00 PM

My dad has one. It has never been used. It is missing a very small piece of the case on top of the bellhousing. You would never see it.

Posted by: JimmyG Feb 13 2011, 04:39 PM

Yea I talked to him yesterday Blake He was at a Porsche club social and was going to talk to you and send a pic of the case and the broken piece.Let me know what you find out.

Posted by: carr914 Feb 13 2011, 05:20 PM

Found It !

Posted by: bam914 Feb 13 2011, 06:59 PM

Pictures are coming.

Posted by: JimmyG Feb 13 2011, 07:07 PM

How much do need to get for it T.C.?

Posted by: ChicagoPete Feb 15 2011, 04:12 PM

I posted over on Pelican too...have a -6 trans sitting around with a bad ring/pinion, if it doesn't work out with T.C. feel free to PM me.

Peter

Posted by: JimmyG Feb 15 2011, 04:47 PM

OK Pete I will do that