Let me know if you have some. Yes I understand 914-6 rotors are available. Any leads on a local machinist in Torrance will be appreciated as well.
Thank you !
If you're going to a machinest anyway, have them machine the less expensive -4 rotors to 5x130 vs. machining an expensive -6 rotor to -4 diameter. Cheaper and the mounting holes line up on the hub.
My $0.04
Hi Ted,
I think I found a pair of rear rotors that have enough meat left to make it worth machining. Getting new -4 rotors is a good way to go as Eric suggested. I think they are about $50 each. I would have to get the rotors turned and redrilled.
Bruce
PM me a price, I contacted your machinist and he was unavailable to drill them, let me know I may have a set of rotors to drill too.
Thanks Bruce !
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)