Printable Version of Topic
Click here to view this topic in its original format
914World.com _ FS/WTB: 914 Parts _ WTB or find heater block cap for 914/6
Posted by: JimmyG May 16 2011, 04:40 AM
In the past I have seen a rubber cap that can be used to block the heat off on a early 911 engine for the summer and then easily be changed for the winter to add heat again. The new style block plates will be to hard to change on the 914 so can any give me some ideas where I can round a couple of these up.
Thanks
Jimmy
Posted by: bdstone914 May 16 2011, 05:05 AM
Is the plate anything like the ones used on J tubes that have a single outlet from the heater blower in the engine compartment?
If it is a round cap what is the diameter?
Do you have a picture of the part that need to be capped off?
Bruce
In the past I have seen a rubber cap that can be used to block the heat off on a early 911 engine for the summer and then easily be changed for the winter to add heat again. The new style block plates will be to hard to change on the 914 so can any give me some ideas where I can round a couple of these up.
Thanks
Jimmy
Posted by: JimmyG May 16 2011, 05:23 AM
Yea The tube that needs to be blocked is similar to the Jtube. I don't remember the diameter of the Jtube but the 911 is about 62mm
I do not have a pic handy this morning.If it measures out the same as the Jtube that would be great! Let me know what you find Bruce.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)