I made the mold and had 904svo lay the fiberglass. I was going to duct air from the fog light opening on the EP car to this. You will need to have short manifolds for this to fit. I am not 100% sure if it will clear the engine lid latch or the trunk torsion bars. When I mocked it up my car did not have them. $100.00obo This is what it cost to have it made.
Here is a picture of the mold in the car.
bump
Any interest in this?
Is Jimmy Hoffa in there? shotgun case?
Blake, does it clear the stock rain tray?
No. It comes right up to the grill. I honestly don't remember what intake manifolds I used when I made it. I think they were the shortest ones I had. Since I built it for my race car that is gone I am not sure if it clears the trunk springs or the latch bracket. All that was cut out of my car. I will let it go for the shipping cost.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)