Putting my car back together, noticed that the 14 pin wire harness that plugs into the relay board has been cut. I need that connector with 6-8" inches of that wire, so I can solder my wires to it.
Also, looking for the barrel nut that attaches to the throttle cable at the throttle body.
PM sent
Bruce
If you can get about two feet it would be better. Stair step your splices so you don't end up with a huge wad in your harness.
Thanks, excellent advice!
I have an extra wiring harness you can have if you pay the shipping? It also has a working ECU attached.
Frank
Take it Garold, I'm after the 14 pin connector thats part of the cars wiring harness, not the 12 pin connector attached to the. FI harness
Yep, that's the one
I have a 14 pin, but it's only got about an inch of wires coming out of it.
I may have one soon....
I am re-wiring Huey and found that I think I don't need the relay board at all....has a 3.2 with it's own ECU and wire harness. I think I only need 1 or two wires that go from the 14 pin to the 12 pin....if that...in which case I'll use weatherpak connectors and eliminate the relay board.
Then again, now that I htink of it...i should have all that from Papa Smurf already. Let me check....
Patrick MS sells the 14 pin new. PN 911 612 113 05 is for the one with male contacts...call them and they can supply female contacts if thats what you need.
Thanks everyone, I purchased one from a world member. No longer in need for the 14 pin connector
Thanks everyone!
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)