I know it's a long shot, but I'm looking to buy a single CV joint for my SIX. I'm trying to win this bet of finishing my car by June 24th and this is going to take its toll.
Thanks, Mark
I believe original NOS CV's are available from HPH in Redwood City CA. Rich has a NOS complete axle and CV's on ebay right now for $359
http://www.highperformancehouse.com
You can also get new joints that have been modified to use on 914's from Eric Shea at PMB Performance. Eric's kit for a single complete CV, boot and hardware is $89
http://www.pmbperformance.com
You can't go wrong either way!
I think that the early 914-6 CVs were 25 spline vs. th 33 or 28. Does empi make a replacement part???
I'm pretty sure I've got a good used one, if you want to go that route. $100 shipped to you.
I know I might have to run a 914-4 axle on one side or just switch both over to the 914-4 models. I will keep the hunt going for the missing CV.
I'll PM those who offered to help to find what items and how much you're selling. I need to get on the contingency plan. I don't want to get this car running and have no ability to make it GO.
Thanks EVERYONE for helping....
914/6 axles and cv had same splines as 911. I don't remember the spline count, but of course 911 cvs were bigger.
Lots of leads...I appreciate the PM's.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)