For a '70 - 4.
Prefer one that not too rusty and that can be cleaned up. Handle would be nice too!
PM me.. ( I have a later one to trade if you need it.)
Brett
I have these...
These jacks were completely disassembled, replated and the proper bits painted to match the original configuration.
This later jack has stamped pieces and is 18 1/2" tall
This jack has cast pieces and is slightly shorter at 16 1/2" tall
The snap ring is slightly cocked in this base as seen in the next picture. It is on solid and doesn't seem to affect anything.
Oooh, pretty! How much? (It'll be nicer than the car! )
I was looking for $100 each.
Sent PM - S O L D!
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)