A while ago I've had a batch of 911ST oil filler necks made, and some folks asked me if I could do a 914-6 GT Oil filler neck.
So I went on the hunt for the correct Tubes for the pressure relief valve, handle for the aluminum cap, measurements etc.
I've made 2 of these filler tubes and due to the work associated (and cost billed to me) I've stopped at these 2.
They are done in the bare form, but need to be cleaned/sanded/blasted and coated to look good.
I would like to sell them off as is in the bare shape, because I don't want to invest more time in this.
They come with the vintage 86mm Aluminum Blau cap with PMB performance handel spot welded on the cap from the inside.
Asking $399 shipped a piece. These are now both spoken for[i]
If you just want an Aluminum 86mm Blau Oil cap, I have a couple of these left.
They are the period item with cork seal and come with a long (5cm) or short (2cm) reciever neck.
Price for this is $150 shipped
I also have one set left with the 86mm Alu Oil cap and a 110mm Stainless Steel Fuel Cap.
The oil cap is the period item with cork seal and come with a long (5cm) or short (2cm) reciever neck. The Fuel cap is a newer production with Rubber seal and also comes with a 5cm receiver neck.
Price for this is $225 shipped
[attachmentid=335
024]
Attached thumbnail(s)
pm sent
PM sent
The 914-6 GT filler necks have been sold, paid and shipped.
I have the basic hardware left to make 4 more of these.
For $225 shipped you get an aluminum cap, short neck, and the required pipes to build one yourself.
Attached thumbnail(s)
HI
I'll take one of the kits.
Will send a PM to arrange getting the $225 to you, and thanks.
Paul
All four 914-6 GT filler kits are sold.
Plenty of Alu oil caps+ receiver necks left.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)