Yep - I have a rediculously steep learning curve when it comes to my 914. So I listened to the "Experts" and I was told that if I didn't have a press to remove my TA bushings then I could heat/drill the bushings, basically mutilating the bushings, and the shafts would fall right out. And of course I dammaged my TA shafts. Sooo I'm in need of some new shafts and while your at it if anybody has an extra castle nut for my ball joint that would be amazing. Please give me a ring.... JohnS@Excelchem.net and tanks a ton!!!
Send a PM to Bruce Stone (bdstone914). He probably has re-plated shafts and nut(s).
I have one you can have for shipping cost or you can come and pick it up in Discovery Bay!!
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)