Printable Version of Topic

Posted by: Garold Shaffer Nov 7 2012, 10:47 AM

These heads have been checked by Len Hoffman (aka Ham Inc). I sold these to another member here a month or so ago, but Len checked them and they are over size so they wouldn't work for the buyer.

Len said that the registers are out to 105.6mm. While you could use these on a stock motor it would over time allow the heads to shuffle, leading eventually to a head leak.

So these are best used if you are going to build a motor with bigger jugs.

There you have it, no BS.

I would like $250 for these plus shipping costs.

And SOLD!


Attached image(s)

Posted by: Mikey914 Nov 7 2012, 12:05 PM

I'll take them

Posted by: mrbubblehead Nov 7 2012, 12:56 PM

right on mark... build a biggun.