Printable Version of Topic
Click here to view this topic in its original format
914World.com _ FS/WTB: 914 Parts _ WTT: Need 914/6 Stub Axles in Good Condition
Posted by: gcrotvik Dec 16 2012, 08:13 PM
I have a set of early 108MM, 2 pin 911 stub axles and 4 matching CV joints, boots and 108MM 901 transmission flanges that I would like to trade for a set of stock 914/6 stub axles. These stub axles work with the early 911 and stock 914/6 hub/axle flanges. I am told this is setup is optimum for high performance 914/6 motor upgrades.
You will need a set of axles to complete this setup. See Eric Shea's article about this setup here: http://www.914world.com/bbs2/index.php?showtopic=91963.
Greg
Posted by: carr914 Dec 16 2012, 10:08 PM
I have a pair of New Mittlemotor 914-6 Stub Axles - No Trades
Posted by: gcrotvik Dec 16 2012, 10:48 PM
I have a pair of New Mittlemotor 914-6 Stub Axles - No Trades
PM sent.
Posted by: euro911 Dec 17 2012, 01:32 AM
You will need a set of axles to complete this setup. See Eric Shea's article on how to preform this upgrade.
Greg
I need to change some old style Nadella shafts to CV type on a '66 912. I have half shafts, CVs and trans flanges, but the stub axles have more splines than my hubs have. The current hubs on the '66 have course splines (don't remember how many off the top of my head).
Posted by: carr914 Dec 17 2012, 08:30 AM
I have a pair of New Mittlemotor 914-6 Stub Axles - No Trades
PM sent.
Back at you!
Posted by: 914Sixer Dec 17 2012, 06:54 PM
Greg,
I have a set of 915 trans flanges that fit the stock tranny. You can then go with 944 cv's on 914 shafts and 911/944 axle stubs.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)