I'm looking for the thin 32MM (1 1/4")wrench required to put turbo tie rod in the 914.. I had it all put in and then realized I forgot the spacers. Once that was put in my wrench just wont get in there. I could grind it down, but figured I'd see if I can get ahold of the proper tool instead. I can't seem to find one online so far.
Also looking for the socket to install the balljoint lock nut..
Thanks,
Mike
Or... any suggestions on what to use instead of the proper Porsche tool ??
The ball joint tool I probably could make something that works.
The wrench I'd just go to Princess Auto, buy a cheap wrench and grind it down.
I'll look at this tomorrow (Monday) for you.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)