I'm looking for a rear tail cone from a 914-6 transmission. Anybody convert one to a side shift and have the tail piece sitting on a shelf?
Thanks, Bill
Bill, Do you have the shift mechanism ? and just need the cover only?
I have the shift mechanism, need the cover. Mounting ear got damaged.
I may have one, I'll check it out tomorrow.
If you need one I can make one from a 914-4, exact...no numbers or anything to tell from factory..I made one for myself, after some ear damage.
Will send pic of one at CAMP tomorrow.
Craig at CAMP
Thanks guys...I thought of remachining a /4 tail cover. Is it difficult to do?
basically, cut the extra length off, machine flat, drill/ream for the bushing and counterbore for the seal. I made a plate that uses the 4 lower cover bolts to hold it in the mill.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)