Printable Version of Topic

Posted by: gcrotvik Jul 16 2013, 07:51 AM

I have a set of later (78-83?) 911 hubs and stub axles for sale. They are in great condition. I am told these hubs can be used as 914/6 hubs with the included spacers. Of course, the bearing races will need to be removed (I did not want to mess with them). Also included but not shown is a set of castle nuts and washers.

Asking $100.00 + shipping.


Thanks for looking!

Greg


Attached image(s)

Posted by: gcrotvik Jul 18 2013, 07:04 AM

Bump.

Posted by: 396 Jul 18 2013, 07:45 AM

If memory is correct, it's the early hubs will fit a 914 hub as the late hubs use a larger bearing.

Posted by: gcrotvik Jul 18 2013, 10:44 AM

I will get some measurements comparing them to a stock set of 914/6 901 hubs. On my initial inspection of these, the outer surface for the bearing race looked the same as my 901 hubs. The only difference I could see is the use of the small spacer/washer on the hub. I will post the measurements when I have them.

Greg

Posted by: SLITS Jul 18 2013, 11:12 AM

AFAIR, these would require a 5 mm spacer on the hub to center the 914/4 or /6 rear caliper or you space the caliper inwards 5mm.

While the bearing is the same, the hub sits about 5 mm deeper than the /6 or /4 hub.

Posted by: gcrotvik Jul 18 2013, 01:28 PM

Slits,

Thanks for the clarification. For those interested, the 5 MM spacers are on the hubs at this time. You can see them above the bearing race in pictures 3 and 6.

Thanks!

Greg

Posted by: jaxdream Jul 18 2013, 05:37 PM

This is a smokin deal !!! If I didn't already have this setup I'd be all over it !! The 5mm spacers allow the use of these wheel hubs to be inserted into 914 rear bearings , put the spacer on the hub , insert into the bearing as usual , the SC bearing is 5mm wider than the 914 4 / 6 bearing and allows the stub to be cinched up giving the preload for the bearing . These should already be sold !!!

Jack

Posted by: gcrotvik Jul 18 2013, 06:33 PM

Sold.