It is final, I'm building a -6 and no longer need these.
These heads were professionally rebuilt and fogged with something to prevent the hardware from rusting since I wasn't sure when the engine would be reassembled.
$300
Attached thumbnail(s)
who did the work?
did the heads require any welding repairs?
are valves stock size?
They came with a project I inherited.
I'll have to measure the valve size and post it.
The engine ( heads) was low mileage, did not suffer failure.
Jim,
good thing you asked.
They're 1.7 heads, stock valves.
Kind regards,
Sunny
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)