FS:Very nice muffler for 914 but not sure for which engine. I am just not a 4 cylinder guy so if someone could help identify the application it would be appreciated.
$150 + shipping or offer.
Thanks
Terry
Attached thumbnail(s)
Measure the distance in between the 2 lower bolt holes and post it. i measured a set of 2.0 he's on an engine and the distance is 20".
Thanks for the heads up!
Exactly what I needed to know.
TOT
So here are measurements:
distance between inner flange bolt holes + 21 3/4"
center line of pipe 23 5/8"
outside of truncated flange 30 3/4"
Hope that helps.
Manufacturer sticker Pacer
If this works for you please make an offer.
Thanks
It appears that you have a 1.7 -1.8 type.
Thanks Bruce
Anyone knows what will be the sound of this muffler? Is it loud? compare to bursch or triad please! I'm interested since my '75 heat exchanger will be replace with earlier Heat Exchanger. Originally I'm planning to install Monza muffler with 4 tip but they said this is a junk muffler.
Thank you!
Probably going to be a little louder than a Bursch flat-pack muffler. It's a 'Cherry Bomb' type glass-pack muffler, so it will flow pretty good.
Sold
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)