I have an Edelbrock SBC intake, that is very low profile, single plane design, that has been machined so the carb sits level with the SBC installed in a 914, and the engine lid will clear a 3 in. large air cleaner. It is in great used condition; no cracks, all threads good, clean, etc. Edelbrock # 3225. Port size: 30mm by 48mm. $100. shipped to lower 48.
930 high grunt Bosch starter, Bosch 101 312 100 fits all 911, 914, 930. It is a fresh rebuilt; shipped in lower 48 for $75. (new around $300.) email here or: tomandgretch@charter.net
Attached thumbnail(s)
Should have added the manifold is set for square bore Holley, or Edelbrock, etc. 4-barrel carbs.
Wow, good deal on the starter ... for all '72~'89 911 motors
Not familiar with the intake, but I can bet that a new Edelbrock manifold sells for much more
i will take the starter
The starter is sold. Manifolds run from $150. up; what makes this one of interest is the machine prep, and it's low profile in the 914 engine bay allows the fitting of a proper air cleaner, which can be a challenge in a lot of the 914-8 conversions.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)