Converting my 72 to side shift. I've got the bar but all the itty bitty mount parts went away with the donor car.
I'm looking for the top "plates" that allow the bar to hard mount to the car as well as any associated bolts, washers, nuts.
Thanks.
I have the brackets that mount to the motor and will just have to get the rubber spacers at some point. If the bolts/nuts/washers are just hardware store items, I guess what I'm in need of is the plates that the ends of the bar bolt to at each side of the engine bay. Part #11 on this diagram.
BTW, are the "bolts" that run up through the bar to the motor mounts threaded dowels with nuts on either end?
I've got those parts. I'll send you a PM.
Carl K.
After the original poster gets his parts I could use a pair too. Bruce, do you have newly plated ones?
I have a set of plates, recently plated...will post a pic later this am
New mount plates...
$35/ shipped
I have a pair. $10 to cover shipping and PayPal fees or free local pickup.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)