Printable Version of Topic

Click here to view this topic in its original format

914World.com _ FS/WTB: 914 Parts _ WTB: Back-Up Light Switch

Posted by: rmital Oct 24 2014, 07:37 AM

looking for a good back-up light switch.
914-613-541-02

I think they are available new from Pelican,
but looking to save some cash since for project car.

thanks,
Ray

Posted by: 914Sixer Oct 25 2014, 07:34 AM

URO is making reproductions in the $30 range.

Posted by: pilothyer Oct 25 2014, 09:05 AM

Ray,
Is yours missing or not working...if it's not working it usually turns out to be the pin that wears out and just gets too short.............the switch rarely fails...easy to test with ohm meter after you take it out.

Posted by: bdstone914 Oct 25 2014, 12:01 PM

I have a couple of used switches that need the ceramic repaired. Both tested and work.
Also have a pin. It could be you need either or both. I recently had to replace both on a trans. I would want $20 for a switch.



Attached thumbnail(s)
Attached Image

Posted by: rmital Oct 27 2014, 06:51 AM

QUOTE(pilothyer @ Oct 25 2014, 11:05 AM) *

Ray,
Is yours missing or not working...if it's not working it usually turns out to be the pin that wears out and just gets too short.............the switch rarely fails...easy to test with ohm meter after you take it out.

after dropping the engine...checking all connections and bits and pieces, the switch looked a little beat up. The ceramic was chewed up.
I figure it would a good time to replace.
it was in working condition, just not very pretty.... biggrin.gif
I will test it though now that it has been roughened up before I button everything back up.

Posted by: rmital Oct 27 2014, 06:53 AM

QUOTE(bdstone914 @ Oct 25 2014, 02:01 PM) *

I have a couple of used switches that need the ceramic repaired. Both tested and work.
Also have a pin. It could be you need either or both. I recently had to replace both on a trans. I would want $20 for a switch.

those look like the one I'm looking to replace.
if I test and it's not in working condition, I'll get back to you.
Thanks!

Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)