Decided not to build a big engine so I'm selling this stuff I picked up in a big parts lot. The 103mm JE pistons and cylinders are brand new but missing wrist pins and have minor dings on head side of one of the cylinders. $400
I also have a 2.0L block with innards and pistons/rods, fan, oil cooler with a GA serial number for $250.
Located in Norman, OK. Will sell the lot for $500 together or trade the Ps and Cs for brand new 1.7L 90mm domed P/C set.
Link to my Flickr album with more pics: https://www.flickr.com/photos/123732647@N02/sets/72157649500001902/
Attached thumbnail(s)
I should mention that I prefer cash and would rather not ship, but arrangements could be made with a good offer.
Attached thumbnail(s)
Bump
Any offers?
Assuming your 2.0L has the stock 71mm stroke crank, you would be at 2366cc. I would think the case will have to be machined to accommodate the larger cylinder OD and the heads will have to be flycut to the larger diameter as well.
Yeah, it would make a 2366cc with the 71mm stroke. As far as I know machining the case and heads is necessary, and the heads may need bigger valves. I've also read that going dual carbs is helpful to attaining maximum hp and performance.
Sending PM on the P&C set
next in line on the entire package
next in line on the entire package
Try and bump this again. Let's work out a deal. Army says I need to move soon and I need to pare down the collection. I also want some money to put into my car. haha
Pistons and cylinders are sold, and engine block may be pending.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)