1975 Porsche 914 2.0L Engine, Complete with Fuel Injection System. #GC000556. Was removed from a sand rail in the last 30 days. Ran great, when removed had dual carbs attached. Some engine tin still attached to backside, includes flywheel. Drop in your vehicle and go! $1,495.00. Buyer pays shipping or local pickup.
Saw your add on Craigslist in Eugene Oregon. I am in Grants Pass. I started a thread to figure out the details http://www.914world.com/bbs2/index.php?act=ST&f=2&t=246751&st=0#entry2122036. So far it looks like I would need the wiring harness from the engine and the ecu and to redo the header/exhaust, which I could probably fabricate if my 1.7 exhaust doesn't fit. How's the compression? Ever do a test on it?
You've got it listed on Craigslist in Eugene for $995 .
Not quite drop in and go. The exhaust and header are for a RWD. The 1.7 exhaust will fit but will be restrictive with smaller tubes. The top tins have been cut and will not seal in a 914. Front engine tins are missing but could be swapped from another engine Need the engine electrical harness to the relay board which could also be swapped from a 1.7L FI engine.
Unable to do compression test! When I bought the engine it was was running strong, sounded great! I would have to hook a transmission and starter back up to check the compression! Turns over freely by hand.
Price reduced to $995.00
I have a starter that goes with the sale.
I have a good looking relay board that goes with the sale.
Sent email and PM...
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)