In need of some engine tins for my conversion, and looking to save some money while im at it.
I cut, hammered, and dollied out the front of a 911 piece to fit the front for the -6. I then made the side pieces out of fresh steel (these are relatively easy to make). The rear pieces are a bit more difficult but can be made out of sheet steel with a bit of welding. So there's your money saved!
I think you can get repro tins for ~200. A relative bargain actually...
PM a914guy - Rich Johnson - You'll get more than just sheet metal. Rich is a great resource for 6 conversion stuff and knowledge.
I think most repro sets go for $350
There also is a thread with templates around here somewhere if you want to make your own.
Search cheap conversion or something like that.
John
In classics
914-6 conversion by root_weeks
I have a used oem set available.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)