Only need one stud, but if anyone has a couple laying around I would take a few just incase. I am wanting to get my spare 1.8 running. TIA
I needed one a year or two ago. Did a search on here and a fellow mentioned having found them at Ace Hardware. Sure enough they had them.
Thanks for the tip, I'll go check them out.
Yes ACE has some, but the selection of lengths is minimal.
You might get lucky.
Otherwise I cut my own from grade 8 metric all thread.
If you havent found any, PM me your address and I'll send you a few.
turns out there isn't an Ace close to me, so I am going to run by the local hardware store and try my luck. I'll let you know if I find something that will work. Thanks
Let me look, I can probably fix you up with a used one.
That would be awesome. Thanks!
Chad,
I found them. Do you need standard or 1st oversize? I have both. Just pay the postage.
Thanks,
Mark
Sorry I didn't see earlier. Standard size, I'll pm you. Thanks!
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)