Looking for set of rear rotors that have been drilled for 5 bolt...Used ok as long as they are good. Thanks
I have a set off a 75 which should work.
I'll measure them and post pics shortly.
Luke
Pelican shows 70-76.
If they haven't been "cut" they should .
Thanks
Both rotors have the set screws drilled for the 5 lug hubs.
Both are 9 mm thick and 282 mm in overall od.
Those are probably 914-6 rotors as they have both pairs of set screw hokes. I don't recall the diameter but the 6 rotors are 4mm larger in diameter.
Bump ...Still looking
PM sent
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)