Printable Version of Topic
Click here to view this topic in its original format
914World.com _ FS/WTB: 914 Parts _ Torsion Bar Backing Plates WTB
Posted by: forrestkhaag Feb 20 2015, 07:55 AM
I am looking for two Torsion Bar Backing Plates / the little triangular three-nuted steel items required to assemble my torsion bar installation. they are available in an aftermarket venue for around 50 bucks so I would like to beat that deal by some number shipped to 92651 Laguna Beach.
My 911 front end is screaming for the upgraded to torsion bars so I will give it a few days to see if someone has a pair laying around collecting dust.
thanks
Posted by: rdauenhauer Feb 20 2015, 02:16 PM
Torsion bars dont have "backing" plates, they install in the A arms and have an adj. cap at the R. facing end.
Did you mean (Anti-) sway bars?
On a stock (914) car there was never a nut plate on the inside of the wheel well.
The pieces I think you are seeking are only aftermarket (Welt.) and were intended to be used where no sway bar was ever installed.
Attached image(s)
Posted by: forrestkhaag Feb 27 2015, 04:09 PM
Torsion bars dont have "backing" plates, they install in the A arms and have an adj. cap at the R. facing end.
Did you mean (Anti-) sway bars?
On a stock (914) car there was never a nut plate on the inside of the wheel well.
The pieces I think you are seeking are only aftermarket (Welt.) and were intended to be used where no sway bar was ever installed.
Sway bar is correct - my mistake in terminology. fabricated this week good to go. Thanks
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)