I'm looking to buy a linkage kit Weber 44 IDFs. I'm not picky on what kind/brand the linkage kit is, but I am looking for a complete set up. Please let me know if you have an extra laying around.
I have bought my rebuild kits through Weber Carbs Direct. I thought their prices were reasonable.
Thanks for the heads up, I picked up a couple kits. Still need a decent linkage kit.
Just FYI, cross-bar linkage (hex, etc) are a nightmare to set up correctly. Save yourself a huge headache and find a bell crank linkage.
Or use http://www.tangerineracing.com/engine.htm, loved it when I had it. Not the cheapest, but like everything else Chris makes its top notch stuff.
i agree with mcmark and 914forme. used hex stuff will require lots of labor to dial in
I wish I could afford the Tangerine stuff, but since this is my 3rd car, I need to go a little cheaper.
Where could I source a good, non-hex type setup?
try McMark
Replied via pm, but for everyone else:
http://www.csp-shop.de/cgi-bin/cshop2/front/shop_main.cgi?func=anzeige&wkid=25700870608&rub1=Engine&rub2=Fuel%20System%2CCarburator%20Linkages%2CBellcrank%20Linkages
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)