951 Turbo Stub Axles for those wanting to do 100 mm CV Joints. They will require spacer washer. $62 shipped
Control Arm Shafts $62 shipped
Upper Steering Shaft $17 shipped
Paypal: a914nut@email.com
Attached image(s)
Hi
I need some rear shafts, Are they factory or after market?
Hi Mark,
Do you need an extra spacer under the nut or on the back side ?
And your parts are way too clean. Your setting a bad example for the rest of us.
Bruce
Spacer goes on the axle shaft bottom to support the bearing because the shelf has been machined off. See the Classic Threads for 944 CV joint installation. Shows location and gives size required. The 951 axles where close to cherry when I got them.
Axle shafts are stock 914 and they are used but in very good condition. I try and sell the best I can get.
I will take the pivot shafts if available. PM sent.
Shafts are sold to Greg.
Stub axles still available.
Do you have rear control arms for sale?
Thanks,
Tom
951 stub axles are sold.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)