I'm looking to buy a full set of core 2.2/6 heads that don't have damage or broken fins
They need to be carb heads from a t spec motor
(Not mfi)
Tia
Do you happen to have a part #, Brant?
I believe I still have a set that came from a Sportomatic 911.
I will get the part #
Thanks a ton Mark for the list!
so the casting number for the ones I need is:
911.104.306.0R
OK, I'll check and get back with you
6 or 12 I have em ,,, not core prices though...
what date code do you need ?? that chart is generic..
I have a couple of sets too. Sent email but no response.
I cleaned up one of them fairly completely, then only cleaned up the combustion chambers on the other five. Five are dated 6/69 and one 7/69.
Plug hole threads all good. Valves look OK & appear to be seated, not sure about condition of guides.
#1 - minor pitting in chamber
#2 -
#3 -
#4 -OOPs - looks like I missed a close-up of one ... it's one of the better looking ones
#5 - A little more sever pitting (must have been the most open intake valve)
#6 - dated 7/69
All 6 - (five are only cleaned on the chamber side)
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)