I'm looking to pull the stock 45mm rear wheel studs and replace with 55mm so I can run some small spacers in the rear of the -6 but having a hard time finding them in stock.
Anyone point me in a direction or have some good used ones to sell?
Thanks,
Dee
Talk to Eric at pmb
I may have 10 of them. I'll check and get back to you later tonight.
That would be great Luke, let me know! I need them next week so I can't really wait for someone to order them and get them in stock and then ship them to me.
I think I have five you can have for the shipping. They are the early 911 8.8 ones. Let me know so I can did them out.
I only have 10 of the 72 mm long studs . Let me know if these will work for you.
Are you looking for wheel studs or bolts?
Eric pointed me to Race-Studs for my 5 lug converter rear hubs.
They have real nice studs available.
http://www.race-studs.com/
What size spacers are you going to run ? 55mm studs would allow up to a 10mm spacer.
I have five 50mm studs that are good for 5 mm spacers.
I was looking to run either 7 or 10mm spacers in the rear.
Luke, thanks for checking, but those are too long.
Mark, thanks very much for the offer but since I'd still be chasing 5 ......
I believe that the closest "stock" studs lengths include 52mm and 66mm
I have both sizes available
Dee,
I just checked mine and they were 45 mm.
Sled9146, sent you a PM.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)