Looking for a decent example of the factory clamp for
the 914-6 oil tank filler neck for my six conversion project.
See pic below, yellow arrow pointing to the clamp.
Sorry for "borrowing" someone's pic here on 914 World.
Thanks
Might still be available from Porsche. Same type of clamp as the heater blower in the engine bay. One of those might do the trick.
Call Patrick MotorSport Phone:(602) 244-0911
I just jot a filler tube from them
Found a factory six clamp from Resto automotive Products.
I believe the part number is 99951207302.
Retro Automotive Parts found me one in their stock pile of clamps for $25.
Unknown if they have any more.
They did have a very similar sized clamp that you could certainly use on the oil filler neck.
[Per an email from them: The clamp you are looking for is only 54mm. The clamp on the heat exchanger to hot air tube is 51-72.
I think, so that would probably work. They have one of those I can sell you for $5.]
Talk to Roger about this.
Contact info:
Address: 91 Main St #500, Claremont, NH 03743, United States
Phone:+1 603-543-1006
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)