Posted by: pilothyer May 19 2016, 11:06 AM
Just can't find the ones I had before the rebuild, but I am at the point where I need a pair of those springy wire gismos that keep the pushrod tubes in their place and snap into the slots on the rocker arm stands.
Another Build about ready to come to life
Posted by: pilothyer May 21 2016, 07:26 PM
I guess these things are really that elusive, not only to me
Posted by: bdstone914 May 21 2016, 07:30 PM
QUOTE(pilothyer @ May 21 2016, 06:26 PM)
I guess these things are really that elusive, not only to me
If you don't find a used set.
http://www.busdepot.com/021109339
Bruce
Posted by: jim_hoyland May 21 2016, 09:54 PM
How many are on the engine ?
Posted by: jim_hoyland May 21 2016, 09:54 PM
How many are on the engine ?
Posted by: bdstone914 May 21 2016, 09:58 PM
Two. One on each head. Going to stock up on some spares Jim?
Yours are probably oil stained.
Posted by: jim_hoyland May 21 2016, 10:39 PM
QUOTE(bdstone914 @ May 21 2016, 08:58 PM)
Two. One on each head. Going to stock up on some spares Jim?
Yours are probably oil stained.
I need to replace the pushrod seals; also considering other replaceable items...
Posted by: bdstone914 May 22 2016, 07:23 AM
QUOTE(jim_hoyland @ May 21 2016, 09:39 PM)
QUOTE(bdstone914 @ May 21 2016, 08:58 PM)
Two. One on each head. Going to stock up on some spares Jim?
Yours are probably oil stained.
I need to replace the pushrod seals; also considering other replaceable items...
No need to replace the wires. I can get you a replated set of P rod tubes which makes the job go faster to have a new set ready to go with new seals and installed on them. I will have a set or two plated in the next run. I have a 5 gallon bucket of them and would like to see the bucket get less full.
Posted by: adidas May 23 2016, 08:28 AM
Ive got a pair if you're still looking.
Posted by: pilothyer May 23 2016, 09:32 AM
QUOTE(adidas @ May 23 2016, 09:28 AM)
Ive got a pair if you're still looking.
Bill PM me with the details............Jerry