For sale: 901 trans that was worked on by Dr Evil.
$2,975.00 (O.B.O.) shipped in the CONUS.
A used Porsche 914 transaxle, that went in for regearing, and general health check up, (032012), and has about 4,000 miles on it since then.
It has a hole the size of a quarter, in the engine console/cap/lid where the black, plastic cap mounts to, that was made to accomodate a cable to pass through, for a cable shifter in it's past. Also, 2 other holes in that same console, with bolts still intact, that are about 3/8" that were used to mount the cable bracket. Has 2 studs on the passenger side, around where the axle comes out that was used to mount a sensor for the speedometer. 1st gear is in there, but has been blocked off/locked out.
It has a 35MM, 904 shaft, a Quaife, LSD, and a billet plate in it.
Current gearing: C-N-Z-fH.
No platic cap for the shift console.
Tranny was never abused.
Bump
I may be interested in that. What output shafts are on there?
That is a great deal, some one please purchase before I do something drastic.
Forgive my ignorance. But, is this for a V8? And, what rpm on the freeway?
Sending PM
Bump
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)