Printable Version of Topic

Click here to view this topic in its original format

914World.com _ FS/WTB: 914 Parts _ brake pad retaining clips springs

Posted by: 87m491 Sep 21 2016, 07:24 AM

Digging into my brakes, 1974 2.0, and looking for these bits. presumably for each caliper, or certainly fronts.
thx
Mike
IPB Image

Posted by: gcrotvik Sep 21 2016, 10:00 AM

I would check with Eric Shea at PMB.

http://www.pmbperformance.com

Posted by: 87m491 Sep 21 2016, 06:48 PM

Thanks, tried there first. Nothing listed on the site under brake accessories.

QUOTE(gcrotvik @ Sep 21 2016, 08:00 AM) *

I would check with Eric Shea at PMB.

http://www.pmbperformance.com


Posted by: Localboy808 Sep 22 2016, 07:20 AM

Don't those come in a set of new brake pads? Pad sets are pretty cheap. Might just be better to get a set at your local parts store. Cheaper than shipping maybe.

Posted by: fduval Sep 22 2016, 07:53 AM

QUOTE(87m491 @ Sep 21 2016, 05:24 AM) *

Digging into my brakes, 1974 2.0, and looking for these bits. presumably for each caliper, or certainly fronts.
thx
Mike
IPB Image


the one on the picture is mostlikely for 911 M calipers,
the 914 retainers are quite smaller .

I do have a set if you need them.

Francois

Posted by: fduval Sep 22 2016, 11:45 AM

QUOTE(87m491 @ Sep 21 2016, 05:24 AM) *

Digging into my brakes, 1974 2.0, and looking for these bits. presumably for each caliper, or certainly fronts.
thx
Mike
IPB Image



here front retainers on the left side of the picture

Attached Image

Posted by: euro911 Sep 22 2016, 11:59 AM

Just a side note, they're not retainers, they're pad spreaders cool_shades.gif

Posted by: 87m491 Sep 22 2016, 06:28 PM

Looks like what I have on one front. I have nothing on my rears....

Posted by: bdstone914 Sep 23 2016, 05:22 AM

QUOTE(87m491 @ Sep 22 2016, 05:28 PM) *

Looks like what I have on one front. I have nothing on my rears....


So what do you need? Fronts or rears or both?

Posted by: 87m491 Sep 23 2016, 07:18 AM

at the moment 1 front and 2 rears...

QUOTE(bdstone914 @ Sep 23 2016, 03:22 AM) *

QUOTE(87m491 @ Sep 22 2016, 05:28 PM) *

Looks like what I have on one front. I have nothing on my rears....


So what do you need? Fronts or rears or both?


Posted by: euro911 Sep 23 2016, 11:22 AM

Another side note: Sometimes, depending on their condition, you may need to install a new rivet in 'previously owned' spreaders.

Posted by: mepstein Sep 23 2016, 01:44 PM

Call Eric. Even if they are not on his site, 99% sure he has them.

Posted by: Mikey914 Sep 23 2016, 09:32 PM

He has or will have them shortly biggrin.gif

Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)