Hey, let me know what you might need, I have a bunch of small stuff for 914. Small niggly part bugging you? Hit me up, I might have it.
I have a bunch of heater tubes, and stuff for the heaters…
Air guide pieces, etc.
Winter is coming, and I hate to throw this good stuff away.
Wiper motor apparatus……..
Do you have a floor mount heater lever control? Good passenger side heat exchanger flapper box?
How about the defrost vents in the dash?
Mohn Ski Rack, 2.o padded steering wheel or center console hinged storage box?
This is like shooting in the dark. I would suggest you divide your parts into small batches, take pictures, price the items, then post them periodically.
Ansbacher
Larmo63, might you have a steering wheel that would fit on a 1973?
AFM for '75 1.8 - 7 pin. Thanks
The ones that go on either end the long rod?
I'm also looking for the front bolster (pad) that attaches to the windshield frame and fits behind the visors. Please respond in thread or PM me if you have a good one. Thanks.
- MR
I'll take the 2 defrost vents pictured for $45.
Thanks
Shift knob that has a clear shift pattern on it, and the two rubber "grabbers" for the targa top in the rear part of the trunk? The shift pattern on my shift knob is barely readable, and one of the rubber "grabbers" on mine is almost split in half. Thanks!
Hello Lawrence,
Checking again to see if you have any sail panel trim - the thinner pieces at the base of the panel.
Andrew
If you have a 914-6 oil tank and/or any of the accoutrement, I could use it.
I do, but they aren't great….
Will send a pm.
Lawrence, do you happen to have a set of rubber "desk pads" for a 73 front bumper?
Thanks
Desk pads?
Splain?
The black rubber pads with rubber nipples. Porsche 91450510710
#28
2.0 SS H.E.'s
ANSA Muffler Quad Tip
Front Blower Motor
Sail Panel (Rollbar) Chrome Trim's
thanks
I have some roll bar trim (the back of the sail "J" shaped pieces) that are in okay condition. Useable, but not perfect.
I have two of the trim that goes under the rear of the targa top. (the one that the "J" moldings cap.
Pm me for pics.
I need some (4) rubber bumpers. the screw in kind for the hood...
How about license plate lights?
Looking for a good early front bumper...have anything?
Thanks!
All bumpers have been sold.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)