Three sets still available still.
I have several pairs of these made after seeing that most of them are badly bent from dropping the trans down without loosening the bolts in the engine bar brackets.
They are made to the same dimensions with a slotted center hole. Made from mild steel and powder coated satin black.
$30 a pair shipped.
Attached thumbnail(s)
I'll take a pair.
PM Sent
Three sets sold, thre sets still available.
I'll take a set as well please.
PM sent
Where exactly do these go? My car is a 72 with side shift conversion and I'm sure it does not have these. Thanks
OK. Duh. I have them, I never paid attention to what the bar bolts to.
Thanks
Bruce
Are these the only brackets that differ from a tail shift engine mount bar? in other words I have a side. shift engine mount bar but not the brackets that go at the ends. For some reason I thought the ones I needed were like a square, steel "box". If these are the ones I need ill take a pair.
[/quote]
You also need the engine to rubber mount brackets. The tail shift uses a one piece bracket and side shift uses two brackets.
A little hard to see but the orher brackets are in the picture near the center rubber mounts.
Attached image(s)
Bump
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)