Printable Version of Topic

Posted by: malcolm2 Oct 27 2016, 08:30 PM

AA had a picture of the single, but no parts and now i can't find the picture.

Tuff to find the part anywhere. Just a 2" long pipe with a rib around the middle.

Option 2 is to buy a couple "Y" connectors and cut the small leg off and use fiberglass to seal it up.

Anyone have either?

Posted by: 76-914 Oct 28 2016, 08:44 AM

IIRC, Mark @ 914rubber is making those.

Posted by: boxstr Oct 28 2016, 09:20 AM

I have These at CAMP 914
Craig at CAMP


Attached thumbnail(s)

Posted by: malcolm2 Oct 29 2016, 12:12 PM

2nd from the left looks like what i have. Can you measure the diameter of the big (black) end? Is that the only one you have? I'd like 2.

Posted by: boxstr Oct 29 2016, 06:52 PM

The one larger y connector is the only one I currently have available.
I will measure this weekend.
Craig at CAMP

Posted by: malcolm2 Oct 30 2016, 10:38 AM

I measured the one I have and the OD measurement of end that inserts into the elbow, your black end is just under 1". 24.5-ishmm

If yours is the same, I need 2, but could live with one. How much do you want for it?

Posted by: boxstr Oct 30 2016, 07:20 PM

It measures 7/8" just under 1". $10.00 to your door. paypal to camp914@comcast.net
Craig at CAMP

Posted by: malcolm2 Oct 31 2016, 07:04 AM

That is fine. PP on the way... I hope you used a flat ruler. Cause your dimension is about 5/16" smaller than my dimension. I used digital calipers.

They have to be the same. It looks exactly like the one I have. Those smaller ones must be D-Jet.

You don't have any non-"Y" (straight) connectors the same size?

Posted by: boxstr Oct 31 2016, 09:17 AM

Measure twice, mail once. I will measure it again this morning.
Craig at CAMP

Posted by: malcolm2 Oct 31 2016, 10:00 AM

I doubled checked my measurement too.

Posted by: boxstr Oct 31 2016, 11:12 AM

Looks like a match to me.
Craig at CAMP


Attached thumbnail(s)