Printable Version of Topic
Click here to view this topic in its original format
914World.com _ FS/WTB: 914 Parts _ FS: Boxster Hubs, One 944 Turbo Stub Axle $89 shipped
Posted by: 914Sixer Feb 4 2017, 03:27 PM
These Boxster hubs will fit in 914 rear arms. You must use a flat plate bearing holder. Grind the ears off of the stock ones or get some all ready done from Tangerine Racing. 944 turbo stub axle is a drop in fit HOWEVER you will need a ring spacer made up for it to make if flush with the bearing. You then can use the 944 CV joint described in the Classic section. On the transmission side you will need 915 coarse spline 100 mm flanges.
I never did get around to fitting a Boxster rotor and caliper for find out how that would work out.
$89 shipped
Paypal: a914nut@email.com
Attached image(s)
Posted by: Chris914n6 Feb 4 2017, 03:30 PM
Do 914 rotors work with these?
Posted by: 914Sixer Feb 4 2017, 04:40 PM
Yes they will but there is no way to secure them to the hub. Screw holes do not line up. Did not see any way to redrill them either.
Posted by: 914Sixer Feb 8 2017, 06:17 AM
Posted by: 914Sixer Feb 18 2017, 05:19 PM
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)