Printable Version of Topic

Posted by: partwerks May 20 2017, 08:55 PM

FS-Clutch cable adjusting bracket.

$30.00 shipped in the CONUS

I made this when I had the WRX engine, and the stock clutch cable seemed a bit long, and so I made this with several adjustment possibilities so I could extend it back to where the cable was more streamlined, and pushed easier.

The bracket mounts to the side of the trans, and then the bracket mounts on it, but had to put about a 1 1/2 tubing to make it level, at least in my scenario. It worked good, but don't need it with the LS conversion, and before I toss it in the iron pile, I was going to see if there was any interest in it first.

I left it long so it could be trimmed off once it's determined the length needed to mount it.