Bursch performance Muffler for the Porsche 914 1.7/1.8 (73-74)
This Bursch was only used for about 300 miles. I had an O2 bung installed for doing some AFR testing. This is quite handy. I also cleaned up the nasty welds at the ports and matched the openings. Stock they are quite bad.
Paint is VHT because the stock Bursch paint burns right off immediately on your first couple of drives. Paint isn't perfect. I also removed the chrome stock tail pipe sleeve. These mufflers sell on the internet for about $350.00 shipped.
These mufflers don't have the best reputation, but it does sound pretty good and seems to make a bit more power. It is basically brand new and ready to go.
Hopping to get $225.00 shipped FedEx Ground in the USA.
Thanks !
Attached image(s)
What is the spacing between the outmost bolt holes on the left and right flanges ?
29 1/2" ?
The welds in the ports were really rough and lumpy Took a bit of time cleaning them up. No extra welds were added.
Interested in the exhaust if Jim is passing.
Sending a PM
SOLD, FourteenFour...
Thanks !
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)