I have a near perfect spare tire hold down plate and bolt that I have replated. The plate had no scratches from the bolt and may have never been used. These are correct for an early car and a 914-6. The washer is not original as it is a stainless steel one I use on brake cylinder push rods. I can plate one of these washers in the next plating run so it matches the gold color of the plate.
$45 shipped.
Attached thumbnail(s)
I will take it. PM sent.
sale pending
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)