Checked out 914Rubber sight but didn't see and and unfortunately I don't know the name of the part. Thanks.
Steve
I don't know if they are available, but I've used two grommets with contact adhesive to glue the small one inside the larger one.
It seems to me that they do offer it, but not all of their products are posted on the website. You probably should give them a call. Ask for the oil temp,sender wire grommet for the taco plate.
On the other hand, I just replaced my entire taco plate and original sender with a new billet aluminum plate and matching sender. It doesn't look stock, but I anticipate no leaks there now.
The usual places (Pelican, AA etc) have them but the problem is most are TOO Large.
We do sell it, just not on the site yet. We have also reproduced the correct wire and ends to add if you didn't have this stock.
I'll have to get Blake to add in as I ave a Burbank turn tomorrow.
Mark
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)