Looks like the enclosed pic, a little over an inch long. They secure the rear trunk lid hinges to the body. I have one, missing one. Please PM me if you have an extra. I can't get my rear trunk lid to stay aligned with a reg. bolt in one side .
Thanks... Terry
About 1.5" long, 12mm socket head, 8mm x1.25 thread size... anyone ?
I have one you can have. PM me your address.
Kevin
There's a modification I do to those. You drill a small hole through the shoulder (like 1/32) and down the center (3/16 IIRC) for a grease fitting. Then you chuck the bolt in your drill press and machine a groove on the same line as the 1/32 hole.
This allows you to grease the pivots
O.K. Kevin ! Thanks for helping out with the shoulder bolt. Now I'll be able to get that rear trunk lid stabilized.
I'm sorry I didn't come through with one. The two on my parts car are so rounded off, the socket wouldn't loosen them. PO must have used a vice grip.
[quot e name='mepstein' date='Sep 13 2017, 03:22 PM' post='2527302']
I'm sorry I didn't come through with one. The two on my parts car are so rounded off, the socket wouldn't loosen them. PO must have used a vice grip.
[/quote]
Hi Mark... I figured if you found a good one you would have let me know . Thanks for checking !
Terry
Drifter,
All of the shoulder bolts I have seen on 914 rear trunk hinges (New and Used) are identical to the short bolt on the right in the picture above. Not sure you are going to find a match for yours.
Cheers,
Dominic
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)