914World.com [Powered by Invision Power Board]

Posted by: tygaboy Feb 26 2018, 05:28 PM

Hi World -
I'll post this same WTB in the cars/roller section, too, since I'd also be interested in taking the whole chassis.

Ideally, this would be located on/near the West coast as I can come and get it.

What have you got?

Thanks -
Chris

Posted by: Mueller Feb 26 2018, 06:04 PM

I think you need entire car... this way you can graft the about 2 or 3 feet of the front end to the front of the back section 2 trunks...

Posted by: tygaboy Feb 26 2018, 06:14 PM

QUOTE(Mueller @ Feb 26 2018, 04:04 PM)

I think you need entire car... this way you can graft the about 2 or 3 feet of the front end to the front of the back section

2 trunks...

Yep, was thinking that same sort of thing: how to "finish" the front part.
I'd take a whole car...

Posted by: rcotten951 Feb 26 2018, 08:53 PM

sent you a PM - located 6 1/2 hours North of you.

Posted by: mbseto Feb 27 2018, 08:22 AM

Did anyone ever buy the Kar-B-Q?
http://www.914world.com/bbs2/index.php?showtopic=323969

Posted by: ric birks Feb 27 2018, 10:53 AM

Good luck with hunt.

Posted by: tygaboy Feb 27 2018, 11:42 AM

QUOTE(mbseto @ Feb 27 2018, 06:22 AM)

Did anyone ever buy the Kar-B-Q?
http://www.914world.com/bbs2/index.php?showtopic=323969

I'm looking for something that needs a bit less work.
It's not going to carry a lot of weight so I figured I'd run it on the stock trailing arms and find a suitable shock/spring set up.

Posted by: Al Meredith Feb 27 2018, 04:58 PM

Probably to far to transport but I have what you are looking for . Could cut in half at doors . The fear fenders and the tail light center piece are perfect , the rear trunk is rusted and would need replacing. I'm in Atlanta, GA.

Posted by: tygaboy Mar 2 2018, 10:07 AM

QUOTE(Al Meredith @ Feb 27 2018, 02:58 PM)