Printable Version of Topic

Posted by: marksteinhilber Mar 23 2018, 02:30 PM

I had good parts left over and made a set of excellent driver quality seats.

New bolster vinyl from 914rubber kits
New metal never break handles from 914rubber too.
I'd have em in my car, but I did two complete recovered seats for it. Once I learned the process, I figured I'd do the work and same another pair from a bunch of cores. I had to salvage lots of clips, pop rivet them on, etc.

This set has a couple minor blemishes including some stitched repair on the side of the headrest. One seat bottom has sensor of unknown working condition. One seat base has metal clip at front. Fiberglass cores were free of cracks and bolster foam was in good condition.

Previous buyer never picked up.
re-listed, prefer local buyer to pick up in orange county. I can also meet during the week closer to LA. PM me

$600 with all rails and bases, will consider OBO, have well over $450 into the parts for these. [attachmentid=643
831]


Attached image(s)